Main Article Content

Mohammed H Mohammed mh805540@gmail.com
Adel M Bash adelbash@yahoo.com


Abstract

The physical isolation of the cause and effect of the car model from the other environment (i.e car body from the car tires) called the suspension system. The goal of any system suspension is to increase    the    ride comfort, road    handling    and stability of closed loop system. The   suspension   design   must   be compensate the effect of conflicting criteria of road holding, both passenger comfort and load carrying. In this research, active suspension system has been introduced. A quarter-car two degree-of-freedom (2DOF) system is designed and constructed to simulate the actions of an active quarter car suspension system. White noise input is introduced to a given system to expressed unpaved road and both step input and sine wave input are studied as well. The control strategy is based on two degree of freedom  PID controller. (MATLAB/ Simulink) is used to verify the proposed algorithm. The comparison between the passive and active suspension and the results obtained from a range of road input simulations in the proposed algorithm shows the effectiveness of the proposed algorithm and best results are obtained.©


© 2019 JASET, International Scholars and Researchers Association

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Article Details

How to Cite
1.
Mohammed MH, Bash AM. PID Controller of a Car with Quarter Body Active Suspension System. jaset [Internet]. 2021 Dec. 26 [cited 2022 Dec. 1];2(1):1-12. Available from: https://isnra.net/ojs/index.php/jaset/article/view/37

References

D Yurlin, “Intelligent systems of the vehicles’ suspension,” OP Conf. Series: Materials Science and Engineering, 2018.

Hakan Yazici. Design of a Parameter-Dependent Optimal Vibration Control of a Non-Linear Vehicle Suspension System . Math. Comput. Appl.2016, 21, 13.pp1-14.

Hu, Y.; Chen, M.Z.Q.; Hou, Z. “Multiplexed model predictive control for active vehicle suspensions”. Int. J. Control2015, 88, 347-363.

Chen, M.Z.Q.; Hu, Y.; Li, C.; Chen, G. Performance benefits of using inerter in semi-active suspensions. IEEE Trans. Control Syst. Technol.2015, 23, 1571-1577.

Al Smadi, T. A. (2013). Design and Implementation of Double Base Integer Encoder of Term Metrical to Direct Binary Code Application. Journal of Signal and Information Processing, 4(4), 370-374.

Hrovat D., Eric Tseng H., Deur J. “Optimal Vehicle Suspensions .A System-Level Study of Potential Benefits and Limitations. In: Lugner P. (eds) Vehicle Dynamics of Modern Passenger Cars”. CISM International Centre for Mechanical Sciences (Courses and Lectures), vol. 582. Springer, Cham, 2019.

Shida Nie, Ye Zhuang, Fan Chen , Jie Xie. “Invariant points of semi-active suspensions”. Advances in Mechanical Engineering, 2018, vol. 10, no.7, pp., 1-14.

Kim C., Ro P. I, “An Accurate Full Car, Ride Model Using Model Reducing Techniques”, Journal of Mechanical Design, 2002, 124, pp. 697-705.

P. Hsu, “Power recovery property of electrical active suspension system”, Proc.31st IECEC, 1996, vol. 3, pp. 1899-1904.

J. Ma Rzbanrrad, N. Zahabi, “H Active Control of Vehicle Suspension System Exited by Harmonic and Random Roads”, Mechanics and Mechanical Engineering, 2017, vol. 21, no.1, pp.171-180.

Marzbanrad, J., Ahmadi, G., Hojjat, Y., Zohoor, H.” Optimal Active Control of Vehicle Suspension System Including Time Delay and Preview for Rough Roads”, Journal of Vibration and Control, 2002, vol.8, pp.967-991.

W.Abbas, O. B. Abouelatta, M. S. El-Azab, A. A. Megahed ,”Application of Genetic Algorithms to the Optimal Design of Vehicle’s Driver-Seat Suspension Model”, Proceedings of the World Congress on Engineering, UK,2010, vol,11.

C.L. Phillips,H. T. Nagle, “Digital Control System Analysis and Design”,3rded. Englewood Cliffs, NJ: Prentice-Hall, 1994.

A S. Emam, “Fuzzy Self Tuning of PID Controller for Active Suspension System”, Advances in Powertrains and Automotive, 2015, vol.1, no.1, pp34-41.

S.S.Khode, A.A. Satam, A.B. Gaikwad, “A Review on Suspension System of Light Commercial Vehicle”, Journal of Mechanical and Civil Engineering, 2017, pp. 14-19.

Bo Huang. “An Energy-Regenerative Vehicle Suspension System – Development, Optimization, and Improvement”. Thesis for the Degree of Doctor of Philosophy, Faculty of Applied Sciences. Simon Fraser University, 2016.

Mirko Coric, Josko Deur, Li Xu, H.Eric Tseng , Davor Hrovat “Optimization of active suspension control inputs for improved performance of active safety systems”, Vehicle System Dynamics,2018, vol.56,no.1,pp. 1-26.

Lou, Z., Ervin,R. D., Filisko, F.E., “A Preliminary Parametric Study of Electro rheological Dampers”, Trans. ASME J. Fluids Eng. ,1994,vol.116,no.3 , pp.570-576.

Sankaranaray V., Emelki E. M. Guvence B. A., Guvenk L., “Semi active Suspension Control of A Light Commercial Vehicle”, IEEE/ASME Transaction on Mechatronics,2008, vol. 13, no. 5.

R. Jeyasenthil S.B. Choi. “A novel semi-active control strategy based on the quantitative feedback theory for a vehicle suspension system with magneto-rheological damper saturation. Mechatronics, 2018, vol. 54, pp.36-51.

Valasek M., Novak M., Silka Z., Vaculin O., “Extended Groundhook-New Concept of Semi active Control of Trucks Suspension”,International Journal of Vehicle Mechanics and Mobility,2007. Vol.27, no.5-6, pp 289-303.

Guvenc B. A., Kural E., Kesli B., Gulbudak K., Gungor S., Kanbolat A., “Semi Active Suspension Control System Development For A Light Commercial Vehicle”, IFAC Proceedings Volumes,2006,vol.39,no.16,pp.391-396.

Lee S., Won-Jong Kim, “Active Suspension Control with Direct-Drive Tubular Linear Brushless Permanent-Magnet Motor”, IEEE Transaction on Control System Technology,2010, vol.18,no.4.

Hac, A. “Suspension optimization of 2dof vehicle model using a stochastic optimal control technique” Journal of Sound and Vibration. Vol.100, no.3, 1985, pp. 343-357.

Wilson, D.A., Sharp, R.S., and Hassan, S.A.: “Application of linear optimal control theory to design of active automotive suspensions”. Vehicle System Dynamics, 15, 2, 1986, pp 103-118.

Ayman A. Aly, Farhan A. Salem. “Vehicle Suspension Systems Control: A Review”. International Journal of Control, Automation and Systems, 2013, vol.2, no.2, pp.46-53.

A.Shahriar, K.A.Rahman, S.Tanvir, “Simulation and Analysis of Half-Car Passive Suspension System”, Mechanical Engineering Research Journal, 2016, vol.10, pp.66-70.

Al-Agha, O. I., & Alsmadi, K. A. (2018). Overview of model free adaptive (MFA) control technology. IAES International Journal of Artificial Intelligence, 7(4), 165.